Free To Air (FTA) Satellite Dish setup

January 20, 2023 – 09:30 am
HOW TO - INSTALL - SATELLITE

I bought everything using ebay, I received everything all at once and quickly with free shipping.

FTA Satellite Dish 33" with mounting hardware $70, HD ready KU band LNB $8, DVBS2 HD Generic FTA Receiver with HDMI $55, RG6 100ft Coaxial Cable $10.

I decided not to install the dish on the side of the house but instead made a free standing base for the dish using 2x4's. Once you pick a location for your dish make sure it is clear of obstructions between the dish and the satellite. Run the RG6 Coaxial cable from the location back to where the receiver and tv are. It is easiest to install the mast before sliding the dish over it, keeping in mind that the mast should be installed perfectly vertical. I used a small level to check my mast before tightening it down. next install the LNB onto the dish and skew it for your satellite. Once you have done that slide the dish onto the mast and adjust the elevation (up/down) to what it needs to be for your location. Most dish mounts have marks on them to indicate this. Once the Elevation is adjusted tighten it down and using your compass point your dish toward your satellite (left/right) Azimuth. Connect and check the signal on the receiver and adjust left/right to get the best signal and then tighten down. There are plenty of tutorials online for installing and tuning a satellite if you need more information check them out.

Source: www.instructables.com


Related posts:

  1. How to install satellite dish and receiver?
  2. How to set up satellite receiver?
  3. DVB Digital Satellite receiver
  4. Best Digital Satellite receiver